Apprentice Vacancies - Design

Permits to Work are an essential tool for managing high risk or infrequent operations. There is a legal requirement to produce them for some tasks, but many systems either don’t control the risks properly or are over-complicated & place a non-value adding burden on the company. This EEF course shows you how to create systems which keep people safe at the same time as allowing you to get the job done.

This one-day practical course is designed to give new and existing crane drivers, slingers and other concerned parties, confidence in the safe operation of cranes and tackle. This training programme meets the requirements under Provision and Use of Work Equipment Regulations 1998 (PUWER) and Lifting Operations and Lifting Equipment Regulations 1998 (LOLER). By completing this course, delegates will meet the legal requirements under the Health & Safety At Work Act 1974.

For anybody involved in the design of products for Assembly or Manufacture, DFMA improves reliability of products and increases production speed. The results generate a reduction in excess inventory and savings in time and materials.

There are many different skills and techniques within the scope of hot working of metals, particularly in the field of cutting. One of the most well-known of these skills and techniques is through the use of Oxy/Acetylene cutters and burners. This one day course seeks to give delegates the necessary training to ensure that they can operate safely and effectively in this particular technique.

The use of inflammable and toxic gases combined with oxygen have long been an integral and commonplace part of welding and cutting techniques in industry. It is so widely used that sometimes people forget about the dangers which results in many people seriously injured or killed each year by the incorrect or careless use of oxy/fuel gas equipment.

An introductory course covering the fundamentals of managing fire risks providing the knowledge to identify fire risks and ensure effective controls and evacuation procedures are in place.

This one day course seeks to give delegates the necessary training to ensure that they can operate safely and effectively in this particular technique.

This one day course seeks to give delegates the necessary training to ensure that they can operate safely and effectively in this particular technique.

If you want to study for an HNC in Engineering but lack the necessary maths qualification (A Level maths or merit in BTEC Level 3 maths) this ‘bridging’ course will give you the skills you need to enrol on the course.

Exclusively for manufacturers, join us for this Brexit update webinar, as we take a look at what steps you can take right now to be able to continue to trade effectively post Brexit.